Eibach Camber Bolts

Apollyon12

Apollyon12

Active member
I recently got a full set of camber bolts from Eibach but I think I am missing something. The rear set went it fine and works great, but not the fronts. The front stock camber bolt has a large elipse near the head and the hole in the strut is signifigantly larger on one side than the other. I get it that this design is needed for the adjustment, but Eibach bolts are a totally different and will not work.

Are you supposed to use the Eibach's in the lower hole in the front (leaving the stock camber bolt installed), rather than the top as you would in the rear?

Is there another type of bolt that I should have ordered for the front instead?

I'm lost.

 
This will answer all your questions.

http://forums.nasioc.com/forums/showthread.php?t=1590221

I actually had them installed incorrectly for a year!
default_eek.gif


 
Ya, I didn't think of putting them in the front lower hole until this morning.

Yesterday was not a good day, I really should not have bee doing work on the car.

 
Last edited by a moderator:
Was that after the autox? I go for beer and TV after a day like that!

That was a super hard course, especially in a faster car.

I think i only had 1 or 2 clean runs. And my wife beat me!

 
You must log in or register to reply here.
Back
Top