fog light troubles

Fozzy

New member
FIXED!

24qjsir.jpg


 
Last edited by a moderator:
try PB Blaster or Liquid Wrench. Squirt generously three times a day for 3 days. If it still wont budge then snap them off, then drill and tap new holes, get new screws.
default_frown.gif


 
Do you think the guys at evergreen could do anything? I think I'm going to get an appointment to get it done fast.

 
Why do you need the fog lamp replaced, or are you just trying to replace the bulb?

Bulb can be had from behind the lamp.

If the lamp is cracked we could run into troubles. The bolts might come out, might need a fog lamp bucket. I can't tell what will be needed until we dig in and attempt a few things.

 
Why do you need the fog lamp replaced, or are you just trying to replace the bulb?
Bulb can be had from behind the lamp.

If the lamp is cracked we could run into troubles. The bolts might come out, might need a fog lamp bucket. I can't tell what will be needed until we dig in and attempt a few things.
all i'm trying to do is replace the bulb. i was trying to change it from the front, but i believe i can go underneath like you are saying.

 
Yes! You did good! I thought about taking the grills off our Fozzy fogs, but them bastid rocks will start going kamikaze on my fogs. I like them without kamikaze rock holes.
default_smile.png


Looks marvelous!
default_biggrin.png


 
Yes! You did good! I thought about taking the grills off our Fozzy fogs, but them bastid rocks will start going kamikaze on my fogs. I like them without kamikaze rock holes.
default_biggrin.png

Looks marvelous!
default_smile.png
thanks a lot! i realized that the head of the screw was a hex head so rather using a screw driver, a wrench was a much more logical way to remove 'em.
default_biggrin.png


i personally like the grilles over the fogs, kinda gives it an offroad look. i'm looking into getting one of the brush guards to kinda get that offroad foz look.
default_biggrin.png


 
Back
Top