how do these heads look?
- Thread starter Evan
- Start date
akinaspeedstar
New member
that looks infected. better put some neosporin on it
other then that i have nothing usefull to add.
other then that i have nothing usefull to add.
internalcombust
New member
looks like the result of a bad valve stem seal.
Runnah
New member
From what I can see 1 of the 4 have a lot more build up. I can see the the other 3 don't have as much. But you can safely say that you're only dealing with a 1/4 of the issue here. The other 3/4 are not part of the problem. Once we take away the problem we can what what isn't the problem. That will give you a much clearer vision of the problem at hand. The real problem is here is the we are dealing with a problem that has no real solution to the problem. I suggest thinking about the solution then going back to the problem to find your answer.
akinaspeedstar
New member
runnah you could have been a consultant
inski
New member
;D = runnah
Why did you pull the heads?
Does look different.
Check you valve faces for nicks indicating contact with something
I'd pop the spring keepers off and see if the valves spin nice and free insde their guide bores, Do this by popping the valve out about a 1/4 inch and spin it with your fingers by the valve stem. If the valve face wobbles at all it has made contact with something and bent. If its not bent then pop all the valves out and clean them til shiny, clean intake and exh chambers, clean combustion area and thoroghly clean the mating plane. Now measure the mating plane with a very flat straight edge cross-wise with your feeler guages. 0.0022" is allowed, anything more your head needs to be planed down flat.
More common issures with heads are warpage, head gasket leaks externally, head gaskets leaks internally..cross leak or coolant leak into a cylinder. And once in a blue moon valve will touch something and bend. Some higher mileage pampered cars will get gummy valves and the seats will get snotty causing poor combustion.
Why did you pull the heads?
Does look different.
Check you valve faces for nicks indicating contact with something
I'd pop the spring keepers off and see if the valves spin nice and free insde their guide bores, Do this by popping the valve out about a 1/4 inch and spin it with your fingers by the valve stem. If the valve face wobbles at all it has made contact with something and bent. If its not bent then pop all the valves out and clean them til shiny, clean intake and exh chambers, clean combustion area and thoroghly clean the mating plane. Now measure the mating plane with a very flat straight edge cross-wise with your feeler guages. 0.0022" is allowed, anything more your head needs to be planed down flat.
More common issures with heads are warpage, head gasket leaks externally, head gaskets leaks internally..cross leak or coolant leak into a cylinder. And once in a blue moon valve will touch something and bend. Some higher mileage pampered cars will get gummy valves and the seats will get snotty causing poor combustion.
internalcombust
New member
Pull the valve check the stem to see if it is straight and replace the valve guide seal. Checking the head for warpage is def needed since it is off. Be crazy not to. I have seen countless motorcycle heads with valves looking very similar and the cause: leaking guide seal.
Evan
Active member
they're not mine, and they're online so i cant do a whole lot to them. if its just a valve guide those are pretty cheap.
i'd be more worried that its a bad stem seal because that would need machining (and who the hell knows how to do that?). a stem seal or even a knew valve is no more than $15 each.
