Replacing Fog lightBulbs 08WRX?

[gakosaurusrex]

well when i read my owner manual it told me to talk to the dealer about changeing them! NOT HOW TO DO IT WTF!!!

dose anyone have any Ideas on how to replace my fog lightbulbs?

 

[Nate]

Best way to get to it is most likely to pull some of the clips on the fender liner, and pull it back, and reach in from there. BE VERY CAREFUL, the liners are not very thick and can rip easy, especially when cold. Good luck.

I did mine with HIDs but I had the bumper off to run the wiring for balasts and whatnot for the headlights and fogs.

Also.... i have my factory fogs sitting here if you want them. $5 for the pair if you haven't bought new ones yet. Heck for $10 ill give you my factory headlight bulbs too.

 

[gakosaurusrex]

Best way to get to it is most likely to pull some of the clips on the fender liner, and pull it back, and reach in from there. BE VERY CAREFUL, the liners are not very thick and can rip easy, especially when cold. Good luck.
I did mine with HIDs but I had the bumper off to run the wiring for balasts and whatnot for the headlights and fogs.

Also.... i have my factory fogs sitting here if you want them. $5 for the pair if you haven't bought new ones yet. Heck for $10 ill give you my factory headlight bulbs too.

I already bought night halk bulbs for the fogs sry nate but when u say fender liner r u talking about the plastic popers holding my front bumper on in the wheel wells?

 

[Nate]

Oh that's ok... I was just trying to give you some bulbs for cheap.

I Mean the pop-it clips holding the black inner fender liner. You will have to turn the wheel all the way one way to access all of them. Im pretty sure there is one that at a weird angle up near the top, and another low near the bottom. Its hard to explain but you will see with some patience and poking around. The biggest pain in the but is that one of the clips is a philips head and chance are you will strip it out. DUMB design.