tumble generator valve

smelt240

smelt240

Active member
Im getting a CEL for the LH tumble generator valve,stuck closed. Is there anything I can do to free it up,or get the motor working again,short of pulling it apart and gutting it? It goes in and out,reset the computer-its usually good for 10 or 20 miles then back on,and back to limp mode.Thanks for any help.

Also,car is an 04 WRX-stage 2 tune, full 3" TBE,up and down pipes,divorced wastegate

 
You could try hitting the motor with the end of a screwdriver. other than that you are screwed. Instead of fixing it I would just do a tumbler delete. then get ahold of Bren and open source the codes off.

 
You must log in or register to reply here.
Back
Top