WTB: Extra bolt from engine...

[Stein]

So I somehow lost a bolt when I went inside for dinner on Wednesday during the snow storm. It's nowhere in the garage, and I didn't see it on any of the ledges in or under the engine bay.

It's a 10mm bolt, not sure length or thread, that holds the dipstick tube steady. Its fine to drive without as far as I can tell, but I'd like to replace the bolt.

Can anybody help me out?

 

[IBratmanI]

I have spares, but I'm sure someone closer has some too

 

[Stein]

I'll keep you in mind just in case

.

I can always try to buy another bolt from a hardware store. I believe the bolt that holds the very last piece on the air intake to the body (just above the pass. headlight) is the same thread, so I can use that as a comparison.

 

[IBratmanI]

yeah just make sure it's metric. Most that you buy at the hardware store will be a different head than the one that's supposed to be there.

 

[-=Lobstah=-]

i have a few. fix you right up when we cut you heat shield. Is it rattling yet?

 

[Stein]

i have a few. fix you right up when we cut you heat shield. Is it rattling yet?

Barely. It started to last thursday, but its still not very bad.

 

[Evan]

i'm sure i have one in cumberland if you want to bother coming by here. home after 5.

 

[Stein]

I could do that. Problem is that I can't until the end of the week when schools done with, but by then I may be going to Lobstah's anyway...

Good news is that you're only 10-15 minutes away (depends where in Cumberland you are).