Apkarian100's 2008 2.5i
- Thread starter apkarian100
- Start date
scubiecraig
New member
apkarian100
Vendor
Either next week or in 2 weeks, getting it welded in Auburn.
apkarian100
Vendor
apkarian100
Vendor
That's where another o2 bung comes in place. It'll be welded behind the secondary cat.
We're going to try and just make an adapter piece first, if that fails, then we'll have to cut the flange off and weld cast.
LA Imports.
We're going to try and just make an adapter piece first, if that fails, then we'll have to cut the flange off and weld cast.
Last edited by a moderator:
apkarian100
Vendor
I don't think so. Both sensors are still in place and should read fine.
$50
how much they doing that for, I just may wanna do this too
apkarian100
Vendor
I feel like there is, just barely, but my main concern in the angle of the uppipe flange on the header. It points up just a little. Hopefully not too much to contact the subframe. See the angle others have done:
Last edited by a moderator:
apkarian100
Vendor
So I got my wheels back from sand blasting. After sand blasting, we noticed a crack along the whole length of one spoke on one wheel. So now that wheel's junk. Off to find another.
In the meantime, today, I painted 3 wheels, with help of Broseph. Paint is a dark grey metallic. It's hard to capture in the pics but the metallic pops like crazy! It was unreal after we laid the clear coat.
Bare sand blasted wheels:
Primerized wheels:
Dark gray metallic, no clear coat:
Dark gray metallic with 4 coats of clear:
In the meantime, today, I painted 3 wheels, with help of Broseph. Paint is a dark grey metallic. It's hard to capture in the pics but the metallic pops like crazy! It was unreal after we laid the clear coat.
Bare sand blasted wheels:
Primerized wheels:
Dark gray metallic, no clear coat:
Dark gray metallic with 4 coats of clear:
Gretsch308
Well-known member
apkarian100
Vendor
In the darkness:
In the light:
Sand blasting vs. finished:
In the light:
Sand blasting vs. finished:
